T6 – NZD/AUD

IMPULSE – CORRECTION – IMPULSE

download (4).png

ENTRY

Daily/4H/1H/30mins timeframe (select only 1)

[1] Price trailed by 30SMA – ensure strength of first impulse wave (✓)

[2] Pullback between 30SMA and 150SMA (✓)

[3] Corrective structure formation with 2×2 touches (✓) Technically yes, however, deemed irrelevant

[4] Stop order at the break of corrective structure with stop loss after swing L/H (✓)

[4] Stop order after price bounce off area of value with volatility stop

Additional confluences: Support or Resistance, ADX35, Linear Trend Lines, Fibonacci Retracement, ATR and Elliot Waves.

1% capital risked for potentially 2R

Open: 0.9155 | Stop loss: 0.9195 (-40 points) | Take Profit: 0.9075 (+80 points)

Remarks: In addition to T2. Both trades currently running.

MANAGEMENT

Keying in the trade, use volatility stop placed under/above an established swing L/H or moving average cross or estimating volatility using ATR.

Real stop loss placed under/above the anticipated swing L/H using 150SMA as a guide.

Take profit calculated using the length of the prior impulse wave rounded off to next nearest swing point/key level.

Once entry triggered and break out, shift automated volatility stop to real stop position.

At 50% of 2nd impulse or a swing L/H established, shift stop to break even.

At about 80% of 2nd impulse, shift stop to the 50% mark or below/above swing L/H.

If price breaks and closes under/above the 30SMA, tighten stop loss and prepare for manual exit.

EXIT

download (5)Screen Shot 2017-04-02 at 2.19.52 AM

[1] Initial stop loss

[2] Trailing stop, as mentioned under management

[3] Manual exit due to change of momentum and break of market structure

[4] Take profit

Note that this happened during the US market closing hours, similar to T4 – EUR/JPY

Idea is still valid… Stop loss intended not reached… Kicked out of the trade… 

Well this is bad, the price discrepancy between FX-IDC on tradingview and CMC markets is disrupting my workflow and messing up the processes.

Will consider using AUD/NZD from now onwards…

OR

Key in trades based on the swing prices of CMC and just use tradingview for analysis but ignore the prices

REVIEW

download (1).pngGot properly stopped out anyway. Still valid points to note though.

Advertisements